Grizzly Vertical Milling Machines G0728 - Manual (Page 27)

Model G0728–31 (Mfg. Since 11/11)
-25-
3. tilt the head to the left or right and use the
head tilt scale to determine the angle of tilt.
4. re-tighten the four hex nuts and lock washers
to secure the head.
To rotate the turret left or right:
1. DisConnECt thE Mill FroM poWEr!
Tools Needed Qty
Wrench 17mm.................................................... 1
Turret Rotation
the turret rotates 360° around the column (see
figure 27).
figure 27. head and turret rotated 45° to the
left.
figure 28. turret rotation hex nuts and lock
washers (2 of 3 shown).
turret hex nuts and
lock Washers (2 of 3)
turret
rotation
scale
3. rotate the head and turret around the column
to the left or right using the turret rotation
scale to determine the amount of rotation.
4. re-tighten the three hex nuts and lock wash-
ers to secure the head and turret in place.
2. loosen the three hex nuts and lock washers
on the turret (see figure 28).
Always lock the turret in place after rotation.
unexpected movement of the head during
operations could cause the cutter to bind
with the workpiece, resulting in personal
injury, and possible damage to the cutter
and workpiece.
Always lock the head in place after adjusting
tilt. unexpected movement of the head
during operations could cause the cutter
to bind with the workpiece, resulting in
personal injury, and possible damage to the
cutter and workpiece.