GE WPRB9250 - Manual (Page 10)

Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
10
About controls features.
STOP
If the washer is running, press once to pause the cycle; press again to cancel the cycle.
START
■ After you have selected a new cycle, press once to start the cycle.
■ Press twice to select the last cycle used and start the washer.
■ If the washer is running, press once to pause the cycle; press again to continue the cycle.
Time Remaining
■ Displays the approximate time remaining until the end of the cycle, or the time remaining
for DELAY START.
■ Cycle time is affected by how long it takes the washer to fill. This depends on the water
pressure in your home. The “smart” timer “learns” the amount of time it takes to fill your
washer and adjusts the total time accordingly.
About cycle options.
2ND RINSE
Adds a second cold rinse to any cycle.
SIGNAL
Alerts you when the cycle is complete.
Press SIGNAL to select low, medium or high volume, or to turn the beeper off.
DELAY START
Use to delay the start of your washer.
Choose your wash cycle and any options.
Press DELAY START. You can change the delay time in 30 minute increments by one of
the following methods, depending on the model:
■ Using the arrow pads beneath the Time Remaining display
■ Repeatedly pressing the DELAY START pad until the desired time is shown
Press the START pad to start the countdown.
The countdown time will be shown in the Time Remaining display.
3
2
1
WARM RINSE
Changes the final rinse of a wash cycle from a cold to a warm rinse.
NOTE: WARM RINSE is not available when choosing a HOT wash temperature.