GE JGP656 - Manual (Page 24)

24
Installation instructions.
Step 8
Install Filters, Check Operation of Downdraft
To raise the vent, turn the VENT knob to
RAISE/LOWER
.
■ Hold the knob until the vent begins to rise. The
vent will automatically stop when it is fully extended.
■ Tip filter into the opening and pull straight down
so that the filter rests on slides.
■ Slide the filter to the right side.
■ Tip the other filter into the opening and pull
straight down.
■ To turn the fan on, turn the FAN knob to HIGH .
Continue turning the FAN knob to select a fan speed
between HIGH and LO
.
NOTE: It is not necessary to turn the fan
OFF before lowering the vent. The fan will
automatically turn off when the vent is lowered.
When the fan is not turned off before lowering the
vent, it will automatically come on at the previously
selected speed when the vent is fully raised.
To lower the vent, turn the VENT knob to
RAISE/LOWER
. Hold the knob until the vent begins to
lower.
Step 7
Assemble Burners, Check Ignition
Assemble burner as shown.
Place the burner heads and caps on the burners.
Make sure that the heads and caps are placed on the
correct size burner. There is one small, 2 medium
and one large head and cap.
Check for proper ignition:
■ Push in one control knob and turn 90° to HIGH
position.
■ The igniter will spark and the burner will light; the
igniter will cease sparking when the burner is lit.
■ First test may require some time, while air is
flushed out of the gas line.
■ Turn knob to OFF.
■ Repeat the procedure for each burner.
Burner Cap
Burner Grate
Burner Bowl
Burner Head
Make sure the slot in the burner
head is positioned over the
electrode.
Front of Cooktop
Medium Head
and Cap
Medium Head
and Cap
Small Head
and Cap
Large Head
and Cap