Goldstar LWJ0611PCG - Manual (Page 4)

—4—
1.5 LOCATIONS OF CONTROLS
1.5.1 CONTROLS
Dry Fan
Cool
ON/OFF TIMER
- STOPPING OPERATION
• Everytime you push this button, when the unit is operating,
timer is set as follows.
(1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours Cancel)
• The Setting Temperature will be raised by 2
°
F(1
°
C) 30min. later
and by 2
°
F(1
°
C) after another 30 min.
- STARTING OPERATION
• Everytime you push this button, when the unit is
not operating, timer is set as follow.
(1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours Cancel)
FAN/COOL/DRY
• Everytime you push this button, it will toggle between
COOL, FAN and DRY.
POWER
• To turn the unit ON, push the button. To turn the unit OFF,
push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is on the High cool mode
and the temp. at 72
°
F(22
°
C).
TEMPERATURE SETTING
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60
°
F(16
°
C) to 86
°
F(30
°
C) by 1
°
F(1
°
C).
Select the lower number for lower temperature of the room.
FAN SPEED
• Everytime you push this button it is set as follows.
{High(F2)
Low(F1) High(F2)...}.
ENERGY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.