GE 45608 - Manual (Page 31)

31
Scenes can include lights from different groups.
Adding a Device (Node / Light) to a Scene
1. Enter Z-Wave setup mode and highlight SCENE SETUP
2. Press OK; the screen will display ADD
3. Press OK; the screen will display SEL DIGIT
4. Press a digit (1-9) for the scene you wish to add the device to.
Press SHIFT and the digit (1-9) if you are adding devices to
scenes 10 through 18. The screen will display the scene
you’ve chosen.
5. Press OK; the letter “W” will be displayed in the upper left hand
corner and the Z-Wave light will begin blinking indicating the
remote is waiting to connect to your device.
6. Press and release the button on the device so it communicates
with the remote.
7. When the screen displays SUCCESSFUL you have successfully
added the Node/Light to a scene. Immediately following this
the screen will display TO ADJUST LEVEL PUSH OK TO SAVE.
8. Within 30 seconds press and hold the button on the device to
adjust the brightness level. Release the button at your desired
setting, then press OK on the remote.
9. When the screen displays SUCCESSFUL you have successfully
added the Node/Light to a scene at your desired setting.
10. To add additional Node/Lights to your scene repeat steps 1
thru 12.
To control a scene:
1. While in the Z-Wave mode press SCENE once to put the remote
in SCENE mode.
2. Press the digit key for the scene you wish to control (1-9).
Press SHIFT and the digit (1-9) if you are controlling scenes 10
through 18. The screen will display the scene you’ve chosen.
• To turn a SCENE on, press and release the CH + key for less
than one second. The screen will display ON above the
selected SCENE.
Scene Setup
Add Remove Delete Label