Grizzly 18 gauge deep stapler Kit H7678 - Manual (Page 14)

h7678 18 gauge deep stapler Kit -12 -
cleaning & lubrication
cleaning
disconnect the stapler from the air supply
before cleaning. Use a good solvent to
clean the nose assembly of the stapler.
always be sure that the stapler is dry
before using it again.
do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
stapler; this may result in leaks and dam-
age to the stapler and the air couplings.
lubricating
figure 7. Lubricating stapler via air inlet.
never use gasoline or other flamma-
ble liquids to clean this tool. vapors
in the tool may ignite, causing the
tool to explode. ignoring this warning
may lead to serious personal injury or
even death!
place two to six drops of pneumatic tool
oil in the nailer air inlet (as shown in
figure 7) every 2 hours of continuous
use. Wipe off any excess oil near the nailer
exhaust to avoid dust build-up. Model
g2820 pneumatic tool oil is available
from grizzly.
another option to manual oiling would be
to simply install a lubricator in your air
compressor line. if your air compressor
line already has a lubricator, then regular
lubrication of your nailer will not be neces-
sary. Just make sure there is always oil in
the lubricator.