Genie SUPERLIFT 33547 - Manual (Page 18)

16 Genie Superlift Contractor Part No. 33547
Operator's Manual First Edition • Ninth Printing
Load Capacity Charts
Observe and Obey:
Failure to properly position the load may result in
death or serious injury.
Verify that the load you wish to raise does not
exceed the maximum load for your load center.
See Load Capacity Chart section.
Tip-over hazard. Raising a load
that exceeds the machine's
capacity may result in death or
serious injury.
A load center is defined as the balancing point
(center of gravity) of a load and must be
positioned within the load center zone.
Tip-over hazard. Failure to position
the load center within the load
center zone may result in death or
serious injury.
Forks
Load Positioning Instructions
1 Determine the weight of the load and the
location of its load center.
2 Measure to the load center from the side of the
load that will be closest to the carriage.
3 Refer to the chart on the next page to determine
if the machine is capable of lifting the weight at
the location on the forks.
4 Place the load so that it rests on the forks, as
close to the carriage as possible.
5 Position the load so that the load center is within
the load center zone.
6 Secure the load to the forks.
measure to the load center
See the chart on the next page for maximum load
centers for standard forks and adjustable forks.
Load Center
Zone