Common terms and definitions – Grizzly 8" Jointer G0500 User Manual
Page 13
G0500/G1018/G1018HW 8" Jointers
-11-
Common Terms and Definitions
Infeed Table:
The infeed table is the table where
the cutting operation begins. When facing the
front of the jointer, it is on the right-hand side.
The wood travels right to left; from the infeed
table, across the cutterhead, and onto the out-
feed table.
Outfeed Table:
The outfeed table is the table
where the cutting operation ends. When facing
the front of the jointer, it is on the left-hand
side.
Cutterhead:
The cutterhead is the cylindrical
assembly that holds each of the jointer knives.
It spins on a horizontal axis between the infeed
and outfeed table, and is covered by the cut-
terhead guard.
Fence:
The jointer fence is the adjustable cast
iron surface that the wood stock runs along
when jointing and surface planing. The fence is
adjustable from 45°-90° to the infeed and out-
feed tables.
Adjustment Levers and Handwheels:
Controls
the height of the infeed and outfeed tables.
Table Lock Handles:
The threaded handles that
must be loosened before the height of the
tables can be adjusted. They are then tight-
ened after the height is properly set.
Rabbet Cut:
A rabbet cut is a groove cut along
the long edge of the wood stock, usually used
for making simple joints. The cutterhead guard
must be removed for this operation, so great
care is needed for safe operation.
Surface Planing:
Surface planing is running the
face of the wood stock over the jointer. This
provides one flat side that is ready to be run
through a dedicated planing machine.
Edge Jointing:
Edge jointing is running the long
edge of the wood stock over the jointer. This
provides one flat edge that is ready to be run
against the table saw rip fence or edge glued.
Cutterhead Guard:
The metal guard that covers
the cutterhead and automatically moves out of
the way during operation, then automatically
moves back into place after the operation.
17.
45˚L Stop Nut
18.
Fence Lock
19.
Fence Tilt Lock
20.
45˚R Stop Bolt
21.
90˚ Stop Bolt
22.
90˚ Stop Tab
23.
Cutterhead
24.
Cutterhead Knife
25.
Gib Bolt
26.
Gib
27.
Jack Screw Access Hole
17
18
21
19
22
26
25
27
24
23
20
Figure 5.
Fence controls.
Figure 6.
Cutterhead details.