Grizzly G0633/G0634 - Manual (Page 26)

-24-
G0633/G0634 Jointer/Planer Combo Machine
Jointer-Planer
Conversion
The Model G0633/G0634 is ready for jointer
operations after it is setup. To use the machine as
a planer, you must perform a conversion.
To set up the machine for planer operations:
1. DISCONNECT THE JOINTER/PLANER
FROM THE POWER SOURCE!
2. Remove the cutterhead guard.
3. Loosen the quick release knobs (Figure 23)
and slide the fence off the machine.
Figure 23. Fence removal.
4. Remove the dust hose from the jointer dust
port.
Quick Release
Knobs
Basic Planer
Controls
This section covers the basic controls used during
routine planer operations.
See Page 22 for a description of START/STOP/
EMERGENCY OFF buttons.
Table Height Handwheel: To move the planer
table, rotate the table height handwheel (
Figure
22).
Table Lock Lever: Turn the lever clockwise to
prevent the table moving during planer opera-
tions; loosen to move the table handwheel.
Table Height Scale: Read depth-of-cut from the
inch/millimeter scale.
Change Lever: When the lever is in the "up" posi-
tion this converts the machine to planer opera-
tions.
Figure 22. Planer table control locations.
Change
Lever
Table Height
Handwheel
Table Lock
Lever
Table Height
Scale