GE 26998 - Manual (Page 9)

9
There are three programmable menus available: Language, Tone/Pulse
Dialing, and Local Area Code.
S
ETTING THE
D
ISPLAY
L
ANGUAGE
1. Make sure the phone is OFF (not in TALK mode).
2. Press and release flash/program button until 1 ENG 2 FRA 3 ESP shows
in the display. The default setting is English
3. Use the handset number pad or press the left or right arrow buttons to
enter the desired setting. For example, to choose English press the
number 1 key.
4. When finished, press and release flash/program button again to store
the setting. You will hear a confirmation tone, and the unit enters the
Tone/Pulse Dialing menu.
T
ONE
/P
ULSE
D
IALING
1. Make sure the phone is OFF (not in TALK mode).
2. Press and release the flash/program button until 1TONE 2PULSE shows
in the display. The default setting is TONE.
3. Use the handset number pad or press the left or right arrow buttons to
enter the desired setting. For example, to choose Tone dialing, press the
number 1 key.
4. Press the flash/program button again to store. You will hear a confirmation
tone, and the unit enters the Local Area Code Setting menu.
S
ETTING THE
L
OCAL
A
REA
C
ODE
1. Make sure the phone is OFF (not in TALK mode).
2. Press and release flash/program button until ENTER AREA CODE shows
on the display.
3. Use the handset number pad to enter your three digit area code.
4. When finished, press and release flash/program button again to store
the area code and exit setup. You will hear a confirmation tone.
NOTE: If you make a mistake, repeat steps 1-3.