GE Calibur CBR-PB3-WD - Manual (Page 14)

Kalatel CBR-PB3-WD 14 0150-0261A
5.2 Configuring the PB3 for POS Interface
1. Associating ECR data to a specific camera.
Dipswitches 5-8 on SW1 are used for assigning an
ECR’s transaction text to a specific camera.
Please refer to Section 8 for the specific dipswitch
camera assignments. The default setting is for
switches 5-8 to be all OFF (All switches Up =
Camera 1).
2. Program the DVMRe for the desired recording functions based upon
the presence of transaction text. In addition make sure the RS-232 port
on the DVMRe is configured correctly set via the DVMRe Setup Menus:
a. COMMUNICATIONS>RS-232>PORT (1 OR 2)>19200
i. Port 2 is used if DVMRe- CT/eZT/StoreSafe
ii. Port 1 is used if DVMRe-CS/CD/eZ
Transaction text is captured with video regardless of the
recording mode (Time-Lapse, Time-Lapse + Event, or Event
Only). If Time-Lapse + Event or Event Only recording
modes must have at least one (1) second set for the pre-
event duration.
3. Process several POS transactions at the Cash Register.
a. To verify proper operation with a DVMRe-CT/eZT/StoreSafe
unit:
i. Select full-screen on the Main Monitor (A) the camera
associated with a PB3 unit. Press the camera button
until the text box window appears in the display.
ii. The text box will display any transaction data as it is
passed to the PB3 unit from the POS device. Be
aware that some POS devices only send transaction
data until the end of the transaction (when the receipt
is printed).
NOTE