Stovax Electric Stove Range - Manual (Page 3)

3
USER INSTRUCTIONS
1. IMPORTANT INFORMATION and
HEALTH AND SAFETY
ALL APPLIANCES DESCRIBED IN THESE INSTRUCTIONS
ARE HEAVY. SEEK ASSISTANCE FOR UNLOADING OR TO
LIFT FOR INSTALLATION.
• Remove all packaging and throw away using your local
recycling facilities
To remove the protective packaging and fitting kit from the
logs inside a new appliance, choose the instruction
corresponding to your model from Section 4 below.
How to Use these Instructions
The contents of Sections 1, 2 and 3 apply to all the models
in our Electric Range.
The content of Section 4, Remove and Replace Door, gives
different instruction for each model type.
• Select the relevant information for your model
1.1 Do not locate this appliance immediately below a fixed
socket outlet.
1.2 All the outer-casing of this appliance is considered by the
manufacturer to be a working surface which becomes hot
when the fire is switched on. You must use a suitable fire
guard to protect children the elderly and the infirm.
1.3 Do not use this appliance in the immediate surroundings of a
bath, shower or swimming pool or any other area where
the appliance could come into contact with water or
humidity, e.g. bathroom.
1.4 WARNING: Do not allow the appliance to be covered or let
the air inlet/outlet to become obstructed as the appliance
may overheat.
1.5 This appliance is not suitable for use outside the house. For
indoor use only.
1.6 Keep the power cord away from hot surfaces and hot
conditions. Do not route the power lead in front of the
appliance.
1.7 This appliance must stand on a clean, level, firm surface. Do
not stand the fire on a carpet. Ensure that furniture, curtains
etc. are positioned no closer than 1 metre and the fire stands
on a surface that can withstand temperatures of 90°C for
prolonged periods. Do not allow rugs to be placed within
500mm of the front of the stove.
1.8 When the fire has been installed, the position of the plug
must be accessible.
1.9 Where the electricity supply cable has to pass through a
fire place, stone surround etc. ensure suitable rubber
bushes are fitted at possible wear points.
1.10 If installed in an open fireplace, blank off the chimney to
reduce the risk of a back draught which can cause the safety
cut-out to operate.
1.11 If the electricity supply cable is damaged do not use the
appliance until it has been replaced. For safety reasons the
replacement has to be carried out by Gazco, a Gazco service
agent or a similarly competent electrician.
1.12 Do not use this appliance with any kind of timer,
programmer or thermal control or other device that will
switch the appliance on or off automatically.
1.13 The appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
1.14 Do not operate the appliance if the appliance is damaged.
1.15 Repairs of electrical appliances must only be performed by
an electrical engineer. Should the appliance fail to operate
or in case of any damage, please contact our service centre
for repair.
2. OPERATING INSTRUCTIONS
2.1 GENERAL
Your fire is remote controlled and can be operated by the
hand held infra red handset or by the controls on the right-
hand side of the appliance.
2.2 PREPARATION BEFORE USE
Batteries :
• Ensure that the handset battery is new and is inserted
correctly
• Dispose of any worn out batteries safely at your recycling
centre on replacement
When using the handset:
• Make sure you point it at the front of the appliance.
2.3 LOCATION OF POWER SWITCH
The mains power switch is located on the control panel on
the lower right-hand side of the stove:
• Switch ON before operating either the Remote control or
Manual controls
A beep is heard to indicate the fire is ready for use.