Goodmans GFSAT200HD/A - Manual (Page 7)

Getting started 04
7
Put batteries in the remote control
Open the battery cover of the remote control and put two
AAA size batteries so that the ‘+’ and ‘-’ marks on the
batteries match the ‘+’ and ‘-’ marks inside the remote
control. Replace the battery cover.
1
2
3
Plug in and switch on
Insert the mains lead into the ‘12V DC IN’ on the
back of the digital box. The standby light on the
front of the digital box will come on.
Switch your TV On and select HDMI.
The first time install screen
The first time installation screen will appear on
screen.
If the signal strength is above 50% press the
[OK] button on your remote control to continue
the setup.
Follow the instructions on screen to complete
the installation.
Step 1 of 6 Step 2 of 6 Step 3 of 6 Step 4 of 6
R
Step 5 of 6
OK Continue
WARNING !
Make sure that your freesat receiver has been connected correctly
before continuing the installation
If signal strength is less than 50%
please check the dish alignment and connections
Signal Strength 100% 50% 25% 75%
Step 6 of 6
First Time Installation
5 4 6
5
+
+
Goodmans GFSAT200HD-A_IB_Rev2_120710.indd 7 12/07/2010 14:11:21