Grizzly 18" x 47" Wood Lathe G0733 - Manual (Page 15)

Model G0733 (Mfg. Since 10/11)
-13-
inventory
after all the parts have been removed from the
shipping containers, you should have the follow-
ing items:
inventory: (figures 3–6) Qty
A. lathe assembly
—headstock (mounted) ............................. 1
—tool rest Base (mounted) ...................... 1
—tailstock (mounted) ................................. 1
—Faceplate 6" (installed) ........................... 1
b. stand legs ................................................. 2
c. machine Feet .............................................. 4
D. tool rest .................................................... 1
E. live Center mt#2 ....................................... 1
f. spur Center mt#2 ...................................... 1
G. indexing pin ................................................ 1
H. hex Wrenches 3, 4, 6, 8mm ..................1 ea
i. Knockout tool ............................................. 1
J. storage Basket ........................................... 1
K. hardware (not shown)
—Cap screws m8-1.25 x 35 .................... 10
—lock Washers 8mm .............................. 10
—hex Nuts m8-1.25 ................................... 2
if any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
B
C
d
e
F
g
h
J
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed. check mount-
ing locations before assuming that any
items from the inventory list are missing.
inventory
figure 4. stand legs.
figure 5. loose inventory components.
figure 6. storage basket.
figure 3. lathe assembly.
a
i