Grizzly 18" x 47" Wood Lathe G0733 - Manual (Page 18)

-16-
Model G0733 (Mfg. Since 10/11)
Assembly
The G0733 and its com-
ponents are very heavy.
Get lifting help or use
power lifting equipment
such as a forklift to move
heavy items.
4. if bolting the lathe to the floor, skip to
Step 7. otherwise, move the tailstock, tool
rest assembly, and headstock to one end of
the lathe bed (refer to
OpERATiONS section,
beginning on page 19, for instructions for
moving these components).
5. use assistants to lift one end of the lathe
onto support blocks and stabilize the lathe
in preparation for installing the machine feet
(see
figure 11).
To assemble your lathe:
1. position the right and left stand legs upright
approximately 57 3 ⁄
4
" apart, and get them
reasonably aligned (see figure 9).
2. Carefully position the lathe onto the stands
and align the mounting holes.
3. secure the lathe assembly to the stand legs
with (8) m8-1.25 x 35 cap screws and 8mm
lock washers, as shown in
figure 10.
figure 10. securing lathe assembly.
x 8
figure 9. supporting legs.
figure 11. legs supported for feet installation.
support Block
6. remove the top hex nut from the feet, then
insert the feet into the mounting holes of the
leg (see
figure 12). do not tighten the hex
nuts yet. remove the supporting block and
repeat
Steps 5–6 on the other leg.
figure 12. machine feet installed.
57 3 ⁄
4
"