Grizzly G1071 - Manual (Page 17)

model g1071 (mfg. 1/02+)
-15-
11. re-tighten the jam nut to secure the table
stop bolt ( figure 12).
8. move the square to various points around
the table to ensure the table and spindle are
square on all sides. adjust the stop bolt as
necessary until the table rests on the stop
bolt and is square with the spindle (
figure
12).
figure 12. Table stop bolt (table tilted for clarity).
figure 13. Pointer adjustment.
scale
retainer screw
scale pointer
12. insert one 3 x 20mm roll pin into the non-
threaded hole in each of the three table
inserts, as shown in
figure 14. make sure
it does not extend through the surface of the
table insert.
13. thread four of the 1 ⁄
4
"-20 x 5 ⁄
8
" set screws into
the threaded holes on each table insert, as
shown in
figure 15.
Note: The roll pins and set screws must not
protrude above the top surface of the table
insert or they will interfere with sanding oper-
ations.
figure 14. Inserting roll pins (bottom view).
table insert
roll pin
figure 15. Inserting set screws.
Flat Top Surface
Set Screws
Roll Pin
Table Insert
table insert
set screw
(1 of 4)
9. tighten both table lock handles when you are
satisfied with the position of the table.
10. loosen the retainer screw (figure 13) that
secures the scale pointer and adjust the
scale pointer to read 0˚. re-tighten the retain-
er screw.