Grizzly G1071 - Manual (Page 27)

model g1071 (mfg. 1/02+)
-25-
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
for optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
loose hardware.
• damaged sanding sleeve.
• Worn or damaged wires.
• any other unsafe condition.
Weekly Maintenance:
•
Clean/vacuum dust buildup from beneath the
table.
Every 1000 hours of use:
•
drain and replace gear oil ( Page 26).
Schedule
Cleaning the model g1071 is relatively easy.
vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. if any
resin has built up, use a resin-dissolving cleaner
to remove it. treat all unpainted cast-iron and
steel with a non-staining lubricant after cleaning.
Cleaning
protect the unpainted cast-iron surfaces on the
table by wiping the table clean after every use—
this ensures moisture from wood dust does not
remain on bare metal surfaces.
Keep tables rust-free with regular applications of
products like g96
® gun treatment, slipit ® , or
Boeshield ® t-9 (see Section 5: Accessories on
Page 23 for more details).
unpainted Cast Iron
Sanding Sleeves
as sanding sleeves are used, they will become
"loaded" with saw dust. if not removed, this saw
dust will harden on the abrasive surface, greatly
reducing the effectiveness of the sanding sleeve.
routinely clean the sanding sleeves with a rubber
gum abrasive cleaner such as the pro-stiK
®
cleaners shown in figure 36.
always discard worn sanding sleeves. as abra-
sives begin to wear, grit will begin to fall off, caus-
ing deep gouges in the workpiece. glue used
to hold the grit to the paper will rub off onto the
workpiece, causing burns and interfering with the
final finishing.
figure 36. Sanding sleeve maintenance.