GE DCCD330 - Manual (Page 3)

■ Properly ground dryer to conform with all
governing codes and ordinances. Follow details
in the Installation Instructions section.
■ Install or store where it will not be exposed to
temperatures below freezing or exposed to
the weather.
■ Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload.
■ Remove all sharp packing items and dispose of
all shipping materials properly.
■ In fulfilling the specific needs of different
commercial installations the purchaser of this
dryer may wish to locate the coin box and
controls in any of a number of locations.
The responsibility for the proper performance
of this work lies solely with the purchaser.
It should be done by properly trained and
qualified personnel, and in accordance with
local code requirements.
■ Any coin box or similar device added to
the dryer, either electrically or mechanically,
should be properly grounded.
■ Remove any accumulated time by manually
rotating timing cam in the coin box
counterclockwise until switch shuts off. Apply
a slight additional counterclockwise pressure to
further seat drive. Make certain not to turn cam
past switch shutoff position. Otherwise, one
increment of time will be gained. Switches are
off when the plastic switch actuating arm (inner)
is down and all 3 switch buttons are depressed.
Exhaust/Ducting
This dryer MUST be exhausted to the outside.
Use only rigid metal 4
″ diameter ductwork
inside the dryer cabinet. Use only rigid metal
or flexible metal 4
″ diameter ductwork for
exhausting to the outside. USE OF PLASTIC OR
OTHER COMBUSTIBLE DUCTWORK CAN CAUSE
A FIRE. PUNCTURED DUCTWORK CAN CAUSE A
FIRE IF IT COLLAPSES OR BECOMES OTHERWISE
RESTRICTED IN USE OR DURING INSTALLATION.
Follow details in the Installation Instructions section.
2
1
PROPER INSTALLATION
This dryer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting ge.com, or by calling 800.GE.CARES (800.432.2737).
3
Safety Instructions
Care and Cleaning
Consumer Support
Operating Instructions
ge.com