Grizzly H0770 - Manual (Page 2)

-2-
h0770 5-shelf Cart
recommended tools
Wrench/socket 10mm ....................................... 1
Wrench/socket 17mm ........................................ 1
hammer ............................................................. 1
Wood Block ....................................................... 1
Clamp ................................................................ 1
assembly
1. place the bottom shelf assembly upside
down on a flat surface, then remove the pre-
installed M10-1.5 hex nuts, flat washers, and
lock washers from the fixed hex bolts.
2. install the locking swivel casters on one
end and the fixed casters on the other end
onto the fixed hex bolts and secure with the
fasteners removed in
step 1, as shown in
figure 4.
handle
figure 5. handles correctly positioned.
6. Fasten the handles to the bottom shelf with
the M12-1.75 x 30 hex bolts and flat washers
(see
figure 6). Finger tighten the bolts for
now.
figure 6. handles fastened to bottom shelf.
x 4
5. place the handles into the sockets at both
ends of the bottom shelf. Make sure the
horizontal supports face inward, as shown in
figure 5.
horizontal
supports
figure 4. Casters installed.
Fixed Caster
3. Flip the bottom shelf assembly over and
place the casters on a flat surface.
4. remove the M12-1.75 x 30 hex bolts and flat
washers from the handle ends.
locking
swivel
Caster
x 16