Grizzly T21347 - Manual (Page 11)

t21347 2" nailer Kit -9 -
A depth adjustment knob is attached to the
nose for setting the nail depth.
to adjust the depth:
1. disConneCt nAiler FroM the
Air supply!
2. rotate the adjustment knob (figure 6)
clockwise to drive the nails deeper or
counterclockwise to drive the nails shal-
lower.
5. pull the trigger.
— if the nail drove into the wood far
enough, continue with your intended
operations.
— if the nail either went too far or not
far enough, then go to the adjusting
depth subsection on this page.
3. depress the safety nose mechanism
against your workpiece.
4. Before pulling the trigger, make sure
your free hand and other body parts
are positioned out of the way of a
potential path of a nail in case of deflec-
tion.
deflection is caused when grain
irregularities, knots or foreign objects
inside the wood cause the nail to
change its path, resulting in the
nail puncturing the surface of the
workpiece, as shown in
figure 5.
Besides damaging your workpiece,
deflection can cause injury if your free
hand is securing the workpiece in the
location that the nail deflects.
figure 5. example of nail deflection.
adjusting depth
3. Connect nailer to the air supply and
test the nail depth, and repeat this
entire procedure if necessary until the
nail depth is satisfactory.
figure 6. depth adjustment controls.
safety nose
Adjustment
Knob