Grizzly H8189/H8190 - Manual (Page 12)

-10-
H8189/H8190 Gasoline Pressure Washer
Figure 3. Model H8189/H8190 accessory
inventory.
A
B
C
D
H8189/H8190 Accessory Inventory (Figure 3)
Qty
A. Chemical Hose ........................................... 1
B. Chemical Filter ........................................... 1
C. O-Ring Seal Kit .......................................... 1
D. Spark Plug Wrench .................................... 1
E. Spark Plug Wrench Handle ........................ 1
F. Input Source Filter ..................................... 1
G. Hose Adapter Male to Male (not shown) ... 1
Assembly
Refer to Figure 1 on Page 4 for identification of
components in the following steps.
To assemble the H8189/H8190:
1. Insert the handle into the frame posts and
push down until the securing pins latch in the
securing pin holes.
Note: You may need to push the securing
pins in to allow the handle to slide into the
frame posts.
2. Thread the spray gun wand into the spray
gun and tighten securely.
3. Connect the male end of the high pressure
hose to the pump output quick coupler.
4. Connect the high pressure hose quick coupler
to the spray gun.
5. Thread the female end of the input hose onto
the pump input port.
6. Connect the other end of the input hose to a
spigot providing at least 5 GPM, or to the in-
feed source filter, if drawing from a standing
water source.
Note: Depending on the spigot fitting type,
you may need to use the provided male-to-
male hose adapter to connect the pressure
washer to this type of water source.
E F