GE Front Load Washer WHDVH626 - Manual (Page 19)

19
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
NOISE Possible Causes What To Do
Washer is noisy Washer is not level • Make sure washer is level and rests firmly on the floor.
Washer load is unbalanced • Press START/PAUSE to stop the washer, open the
door and redistribute the load evenly. Close the door
and restart.
Squealing sound or hot • Washer is overloaded. Stop washer and reduce load.
rubber odor
Shipping bolts and foam block • See Installation Instructions for directions to remove
have not been removed shipping bolts and foam block.
Rattling and clanking caused • Check drum for foreign objects. Turn items with
by foreign objects in tub metal fasteners inside out. Check pump filter.
or pump or metal fasteners
hitting tub
PERFORMANCE Possible Causes What To Do
Lint or residue on Incorrect sorting • Separate lint producers from lint collectors.
Washing too long • Select a lower soil level.
Detergent not dissolving • Try a liquid detergent.
• Use warmer water temperature.
Overloading • Wash drum may be fully loaded with loosely added items.
Incorrect use of fabric softener • Check fabric softener package for instructions and follow
directions for using dispenser.
clothes
OPERATION Possible Causes What To Do
Washer pauses in cycle The washer normally pauses
between washing steps
Washer won’t operate Washer is unplugged • Make sure cord is plugged securely into a working outlet.
Water supply is turned off • Turn both hot and cold faucets fully on.
Circuit breaker/fuse is • Check house circuit breakers/fuses. Replace fuses or
tripped/blown reset breaker. Washer should have separate outlet.
Controls are not set • Hold START/PAUSE button for 3 seconds to start cycle.
properly
Door is open • Close door and press START/PAUSE.
Door is locked • If door is locked with START/PAUSE blinking, press
START/PAUSE two times to unlock the door.
Washer won’t spin Door is open • Make sure door is closed.
Motor is overheated • Washer motor will stop if it becomes overheated. It
will automatically restart after a cool down period of
up to 30 minutes (if washer has not been manually
turned off).
Washer load is unbalanced • Washer has detected excessive unbalance and will
automatically attempt to rebalance load.
ge.com