Grizzly G7947 - Manual (Page 25)

G7947/G7948 12 Speed Floor Drill Press
-23-
Components and Hardware Needed: Qty
Table ...................................................................1
The table must be installed to properly support
the workpiece during operation.
To install the table:
1. Insert the table shaft into the table support
assembly.
2. Tighten the small locking lever to secure
the table in the table support assembly. The
table should now be installed as shown in
Figure 19 or 20, depending on your model.
Table
Components and Hardware Needed: Qty
60 W Light Bulb ..................................................1
The Model G7947/G7948 includes a light socket,
intended for 110V usage only. When the drill
press is shipped from the factory, a dust plug is
installed in the light socket for protection.
To install a light bulb in the drill press:
1. Remove the dust plug from the light socket.
2. Install a 60W or smaller light bulb in the loca-
tion shown in Figure 21.
Light (110V Only)
Figure 19. G7947 table installed.
Figure 20. G7948 table installed.
Figure 21. Light bulb access location.
Light Bulb
Access Here
Using light bulbs at 220V will destroy or
explode the light bulbs because the light
socket is not wired or intended to be wired
for 220V.