Grizzly G0583 - Manual (Page 15)

G0583 1 HP Canister Dust Collector -13-
Components and Hardware Needed: QTY
Base ...................................................................1
Casters ...............................................................4
Round Support ...................................................1
Rectangle Support ..............................................2
Impeller/Separator ..............................................2
Handle ................................................................1
Hex Bolts 5 ⁄
16
"-18 x 1 ⁄
2
" ........................................6
Hex Bolts M6-1.0 x 10 ........................................4
Acorn Nuts
5 ⁄
16
"-18 .............................................4
Flat Head Screws M6-1.0 x 10 ...........................2
Phlips Screw 10-24 x
3 ⁄
8
" ................................... 1
Flat Washers 5 ⁄
16
"-18 ...........................................2
Tools Needed:
Wrench or Socket 12mm ....................................1
#2 Phillips Screwdriver .......................................1
To assemble the dust collector base:
1. Make sure the dust collector motor is
unplugged!
2. Install the the casters with the four 5 ⁄
16
"-18
acorn nuts and washers. (see Figure 6).
Figure 6. Installing casters.
Figure 8. Impeller/separator attached to base.
Base and Supports
Figure 7. Impeller/separator supports.
4. Place the round and rectangle supports on
the base and install with six 5 ⁄
16
"-18 x 5 ⁄
16
" hex
bolts (see Figure 7).
5. Align the impeller/separator assembly with
the supports, and install six 5 ⁄
16
"-18 x 1 ⁄
2
" hex
bolts (see Figure 8).
6. Position the elbow as shown in Figure 8,
and secure it in place with the #10-24 x 3 ⁄
8
"
phlips head screw.
7. Position the handle as shown in Figure 8,
and secure it in place with two M6-1 x 10 flat
head screws.