GE EPM9450Q - Manual (Page 254)

246 PMCS Interface Toolkit
Setup
The screen explains various parameters related to setup.
Current Set Points: Above and Below Current Setpoints are shown for Phase A, B, C, Measured and Calculated.
Voltage Set Points: Above and Below Voltage Setpoints are shown AN, BN, CN, AB, BC, CA and Aux.
PT Ratio: Displays Phase and Auxiliary values for Numerator and Denominator.
CT Ratio: Displays Phase and Neutral values for Numerator and Denominator.
Communication Parameters: Displays Port Addresses and Baudrate for each of the 4 Ports.
Reset: This wizard allows user to reset the following Parameters.
• Energy
• Log
• Maximum and
• Minimum
Voltage Phase Sequence: Displays Phase sequence as either C-B-A or A-B-C, based on the register value.