Grizzly G1023 - Manual (Page 27)

-26- G1023 Heavy-Duty Table Saw
Figure 39.
The shielded ball bearings in the motor and
throughout most of the model G1023 require no
further lubrication during their lifetime. When they
do wear out, replacements can be obtained
through the Grizzly Parts Department.
Your saw requires lubrication in several other
locations, however. Lubricate the areas indicated
below every 12 months.
1. Blade angling trunnions . These should be
lubricated with 6 or 7 drops of light machine
oil.
2. Blade height trunnion . This should also be
lubricated with 6 or 7 drops of light machine
oil.
3. The two (2) worm gears should be lubricat-
ed with a automotive wheel bearing grease.
The blade angle worm gear is not shown in
Figure 39.
These points can be reached by removing the
table. Check all adjustments when finished lubri-
cating.
Lubrication
Figure 38.
Motor Mount Bolt
To adjust V-belt tension:
1. Loosen the motor mount bolt. Figure 38.
2. Shift the motor up or down to increase or
decrease the V-belt tension. Tighten the
motor mount bolt.
3. Check the V-belt tension again. Ensure that
the motor pulley and arbor pulley are lined
up.
To replace the V-belts:
1. Remove the blade.
2. Adjust the arbor so it is down all the way and
in the straight up position.
3. Loosen the motor mount bolt. Prop the motor
up with a board so the V-Belts stay loose on
the pulleys.
4. Pull off the old V-belts and replace them with
new ones. Have the number from the belt
ready when calling the service department
for replacements.
5. Remove the board and adjust the V-belt ten-
sion.
6. Tighten the motor mount bolt.