Grizzly H3118 - Manual (Page 15)

H3118 Tile Saw
-13-
Lubrication
Water is used to cool and lubricate the saw blade
when cutting tile. Water also reduces the amount
of tile dust produced. Fill the water tray with water
before making any tile cuts. The water level should
be above the blade cover base when the water
tray is under the saw as shown in
Figure 8.
Figure 8. Correct water level.
Maximum Water Level
6. If not already installed, plug the switch key
into the power switch. Verify that the machine
is operating correctly by turning the machine
ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7. Turn the machine OFF.
8. Remove the switch disabling key, as shown
in Figure 7.
9. Try to turn the start the machine by flipping
the toggle switch to the ON position.
—If the machine does not start, the switch
disabling feature is working as designed.
—If the machine starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Figure 7. Removing switch key from toggle
switch.