GE MDS 05-4558A01 - Manual (Page 13)

10 MDS Mercury Series Startup Guide 05-4558A01, Rev. C
TRANSMITTER POWER & ANTENNA TEST
The following procedure may be used to measure the transmitter’s RF
power output and SWR “match” of the antenna system. A directional
wattmeter is required for the test, such as a Bird Model 43, with an
appropriate element installed.
Before you start, keep in mind that using the Test Mode will disrupt
network operation.
Procedure
1. Connect a directional wattmeter between the ANTENNA port and
the antenna system.
2. Place the transceiver into the Radio Test Mode.
Main Menu>Maintenance/Tools Menu>Radio Test>Radio Mode>Test
NOTE: The Test Mode has a 10-minute timer, after which it will
return the transceiver to normal operation. The Test Mode can
also be terminated manually, via the menu.
3. Set the transmitter RF output power to +28 dBm.
Main Menu>Radio Configuration>Transmit Power
NOTE: The Test Mode RF power setting does not affect the output
level during normal operation
4. Activate (key) the transmitter.
Main Menu>Maintenance/Tools>Radio Test>Test Mode>
TxKey> Enable
Use the spacebar to key and unkey the transmitter ON and OFF
(Enable/Disable).
5. Using the wattmeter, measure the forward and reflected power
into the antenna system and calculate the SWR. The ratio should
be less than 2:1. Higher levels may indicate a problem with the
antenna or feedline.
6. Turn off Test Mode at the Access Point and Remote radio.
Main Menu>Maintenance/Tools>Radio Test>Radio Mode>Normal