Grizzly G0489 - Manual (Page 13)

G0489 Metalworking Sander
-11-
Inventory
After all the parts have been removed from the
two boxes, you should have the following items:
Box 1: (Figures 4 & 5) Qty
A. Metalworking Sander .................................. 1
B. Spark Trap .................................................. 1
C. Eye Shield .................................................. 1
D. Rest ............................................................ 1
Hardware Bag (not shown) ......................... 1
— Hex Bolt M12-1.75 X 30 (Base) .............. 1
— Hex Nut M12-1.75 (Base) ....................... 1
— Flat Washers (Base) .............................. 2
— Sleeve .................................................... 1
— Cap Screw M5-.8 x 50 (Eye Shield) ....... 1
— Angle Adjustment Lever ......................... 1
— Rest Lever ............................................. 1
— Square Nut ............................................ 1
Figure 4. Model G0489 Inventory.
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
A
B
C
D
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.
E. Base ........................................................... 1
Figure 5. Model G0489 Base.
E