Grizzly G4000 - Manual (Page 11)

-10- G4000 9'' x 19'' Lathe
F Fiig gu urre e 3 3.. Chuck removal bars in place.
Use the chuck removal bars supplied to remove
the 3 or 4-jaw chucks.
F Fiig gu urre e 3 3.. Use one bar to
hold the spindle stationary, the other to unscrew
the chuck. Turn the chuck counter-clockwise to
remove.
To mount one of the standard chucks, line up the
desired chuck (or face plate) with the threaded
spindle. Thread the chuck in place. Take care to
ensure that the threads on both the headstock
and the chuck are clean and free of obstructions
before mounting.
L Liiv ve e C Ce en ntte err
The live center is used to support stock which is
too long to be supported by the chuck alone.
Stock protruding more than three times its diam-
eter should be supported by the live center.
The tailstock barrel and live center have a Morse
taper #2. Before assembling these, insure that
the mating surfaces are “white glove” clean.
These parts will last longer and remain accurate
when properly maintained. Insert the end of the
live center into the tailstock bore until it seats. The
force of a mounted workpiece will fully seat the
taper.
When using a live center, the tailstock barrel
should protrude about
1 ⁄
2
'' and not more than 3''.
S Se ee e F Fiig gu urre e 4 4..
To remove the live center, back the tailstock bar-
rel all the way into the tailstock casting. The live
center will pop out. Be sure to catch it when it
comes out to avoid damaging the tip.
F Fiig gu urre e 4 4.. Live center installed in tailstock.
N Ne ev ve err lle ea av ve e a a c ch hu uc ck k k ke ey y o orr c ch hu uc ck k rre em mo ov va all
b ba arr iin n tth he e c ch hu uc ck k o orr s sp piin nd dlle e w wh he en n tth he ey y a arre e
n no ott iin n u us se e.. IIff tth he e m ma ac ch hiin ne e iis s a ac cc ciid de en ntta alllly y
s stta arrtte ed d w wiitth h tth he es se e iin n p plla ac ce e,, tth he ey y c ca an n
b be ec co om me e p prro ojje ec cttiille es s a an nd d c ca au us se e s se erriio ou us s
iin njju urry y..