Grizzly G4000 - Manual (Page 26)

G4000 9'' x 19'' Lathe -25-
B Be ea arriin ng g P Prre ello oa ad d
This lathe is shipped from the factory with the
bearing preload already set. If the preload
requires resetting for whatever reason, please
contact our service department for further
instruction.
M Mo otto orr -- The bearings used in the motor are
shielded and lubricated for life.
W Wa ay ys s,, S Slliid de es s -- Apply oil to the ways and slides
after each use. Wipe the ways with a clean rag
prior to lubrication to ensure that no grime is car-
ried along with your lubricant into friction-sensi-
tive areas. Applying oil to the bedways and other
bare metal parts also protect the lathe from rust
and pitting.
L Le ea ad d S Sc crre ew w -- Be sure to lubricate the leadscrew
and the leadscrew bearing at the tailstock end of
the lathe.
F Fiig gu urre e 3 39 9..
T Ta aiills stto oc ck k -- The tailstock is fitted with one oiling
point. Apply oil each week, or after every five
uses (depending on the frequency of operation).
F Fiig gu urre e 4 40 0..
F Fiig gu urre e 3 39 9.. Leadscrew bearing lubrication point.
F Fiig gu urre e 4 40 0.. Tailstock oiling point.