GE PTD915 - Manual (Page 15)

Safety Instructions
Operating Instructions
Care and Cleaning
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
15
Step 2—Install Warming Drawer
Slide the left corner into opening and push
power cord into the hole leading to the
outlet location. Thread the cord through
as drawer is being pushed back into the
opening.
If the outlet is installed inside the
opening, plug the cord into the outlet.
In this location, the excess power cord
should be coiled and taped to the right
side of the unit. Make sure the cord does
not get trapped by the drawer.
NOTE: Insure that the power cord does not
contact the hot surfaces on the bottom of
ovens, cooktops, or any other appliance.
Push the drawer back until the front flange
is flush to the cabinet front.
Open the drawer fully.
Drill pilot holes through the holes in the
overlapping frame, one on each corner.
Drive wood screws provided into each
corner.
Read these instructions completely and carefully.