GarrettCom Magnum 10Mb/s User Manual
Page 37
Magnum 10Mb Media Converters
Installation and User Guide (07/98)
GARRETT
30
1. Using standard 10BASE-T media, insert either end of the cable with an RJ-45
plug into the RJ-45 connector of the Magnum Media Converter.
2.
Connect the other end of the cable to the corresponding device.
3. Use the LINK LED (non-Link pass-through models) to ensure proper
connectivity by noting that the LED will be illuminated when the units are
powered and proper connections established. If the LINK LED is not illuminated,
change the setting of the up-link switch (See Section 4.4 for up-link switch
information.) If this does not help, ensure that the cable is connected properly at
both ends and is not defective.
4. For the TF15LP model with the Link-Pass-through feature, The two LINK LEDs
operate together, and either both LEDs are lit or neither is lit. Both of the
attached cables must be operable for LINK to be indicated. Absence of LINK
does not point to the problem cable segment, and the fault may be in either.