Grizzly Model G8592 - Manual (Page 6)

G8592 3.6V Cordless Screwdriver/Flashlight -6 -
BEFORE YOU START
Unpacking
When unpacking, check to make sure all
of the following parts are included:
1 Cordless Screwdriver w/ Battery
1 Cordless Flashlight w/ Battery
1 Charging Adapter
1 Bit Extension
1 Square Drive Adapter
1 Double End Phillips ® /Straight Bit
8 Sockets (6mm - 13mm)
4 Straight Blade Screwdriver Bits
4 Phillips ® Screwdriver Bits
4 Posi-Drive ® Driver Bits
8 Torx ® Driver Bits
8 Hex Driver Bits
If any parts are missing, please contact
Grizzly’s Customer Service department at
the phone number provided on the
Warranty/Returns page.
the storage capacity of the battery it should
be completely discharged (turn the flash-
light and screwdriver on and let them run
until the batteries discharge), then fully
recharge for 10-12 hours.
For optimal life span, completely discharge
the battery after every use. Follow the
instructions below to charge your battery
NOTE: The battery does not need to be
removed from the tool in order to be
charged.
1. Plug the adapter into an appropriate
110/120V outlet.
2. Plug the other end of wire with the pin
plug into the receptacle on the base
of the Screwdriver or Flashlight bat-
tery pack (See Figure 2) .
3. Let the battery charge for 10-12
hours. This will give the battery a full
charge. DO NOT let the battery
charge for more than 12 hours.
4. When charging is complete, unplug
the pin plug from the battery pack,
and unplug the adapter from the wall
outlet. The accessory should be
ready to use.
Fig 2 . Plugging charger into battery.
Fig 1 . Kit Contents (case not shown).
Initial Charging
The batteries in your new Cordless
Screwdriver/Flashlight Kit will not be fully
charged when you receive it. To maximize