Grizzly Model G8592 - Manual (Page 7)

G8592 3.6V Cordless Screwdriver/Flashlight -7 -
OPERATION
Inserting and Removing
Drivers and Sockets:
The hex end of the screwdriver bits fit into
the hex opening on the end of the cordless
driver. The bits can be inserted directly into
the tool, or if additional extension is
required, you can insert the bit extender
first, then mount the bit on the end of the
extension (See Figure 3 ).
When using the supplied sockets you will
need to use the square drive adapter
which is included. You can easily distin-
guish this from the other drivers by the
spring loaded detent ball on the square
end. This helps to lock the socket into
place on the end of the driver. Attach the
socket to the adapter, then insert the
adapter into the end of the driver tool.
Torque Setting
Turn the torque setting dial to the desired
torque setting (See Figure 3) . Line up the
number on the torque dial with the small
arrow embossed on the left hand side of
the case. Torque setting “1” has the high-
est torque, setting “6” the least. Use only
the necessary amount of torque to avoid
damaging the material you are driving into
or the tool.
The driver has a maximum speed of 150
RPM.
Fig 3 . Using bit extension.
Torque Setting Dial