Grizzly Angle s T10493 - Manual (Page 10)

t10493, t10494 & t10495 (Mfg since 10/11) -8 -
power connection
polarized plug requirements
this grinder is equipped with a 16aWg
power cord and typical 1-15 polarized
plug. this plug may only be inserted into
a typical grounded receptacle (outlet) one
way. do not attempt to force it into the
receptacle. ensure that the plug is fully
inserted before operating this tool.
after you have completed all the previous
setup instructions, the tool is ready to be
connected to the power supply.
to avoid unexpected startups or property
damage, use the following steps whenever
connecting or disconnecting the tool.
connecting power
1. turn the tool power switch oFF.
2. insert the power cord plug into a match-
ing power supply receptacle. the tool is
now connected to the power source
(see
figure 7).
figure 7. Connecting to power.
figure 8. disconnecting power.
1. turn the tool power switch oFF.
2. grasp the molded plug and pull it com-
pletely out of the receptacle. do not pull
by the cord as this may damage the
wires inside (see
figure 8).
disconnecting power
serious injury could occur if you
connect the tool to power before
completing the setup process.
do not connect to power until
instructed later in this manual.