Grizzly Angle s T10493 - Manual (Page 12)

t10493, t10494 & t10495 (Mfg since 10/11) -10 -
section 4: operations
eye inJury hazard!
Wear safety goggles with full eye
protection from all sides when using
this grinder.
accidental
start hazard!
disconnect power
before service or
wheel changes.
Wheel shatter
hazard!
never exceed rpm
rating for wheels.
lung/ear
inJury hazard!
Wear protective
equipment when
using this tool.
this tool presents serious injury
hazards to untrained users. read
through this entire manual to
become familiar with the controls
and operations before using the
tool!
using the angle grinder
read and understand all safety instructions
in this manual before starting.
always test on a scrap piece of material
similar to the workpiece. trial and error is
often the best way to determine the ideal
setup.
to use the angle grinder:
1. if the workpiece is not completely stable
on its own, make sure it is securely
held in a vise or a similar device that
will ensure it does not move during
operation.
2. Make sure the grinding wheel is proper-
ly secured on the spindle by tightening
the outer flange.
3. attach the grinder to the correct power
supply.
4. hold the grinder securely in both hands,
and turn it ON.
5. ease the wheel against the workpiece
with a light but steady pressure.
6. turn the grinder OFF.
never use this tool without the
guard installed. do not modify
the guard in any way. using this
tool with a removed or modified
guard greatly increases the risk of
personal injury.