Grizzly H6247 - Manual (Page 8)

Model H6247 Meat Grinder -6 -
Assembling Grinding
Head
5. Carefully slide the cutting blade on
the square shaft on the front of the
feed screw (
Figure 3).
6. Choose one of the two cutting plates.
7. Slide the cutting plate over the shaft
and the locking pin located at the bot-
tom the barrel (
Figure 4 ).
8. Screw the locking ring on the barrel
clockwise to secure the assembly.
Note–Use mild pressure to tighten.
Overtightening can cause the cut-
ting blade to bind against the cutting
plate.
Figure 4. Cutting plate installation
Figure 2. Feed screw installation
Figure 3. Cutting blade installation
1. Loosen the locking ring, and remove
the barrel from the grinding motor
housing.
2. Unscrew the lock ring and remove
the cutting plate, cutting blade, and
feed screw. Thoroughly sanitize the
grinder head and throat, barrel, cut-
ting plates, cutting blade, feed screw,
lock ring, locking knob and hopper
(refer to Proper Sanitization on
page
9).
3. Before proceeding with assembly,
wipe down the outside surface of
grinder motor housing with a sanitized
cloth.
4. After cleaning, assemble the grinder
head by inserting the feed screw into
the barrel with the vertical slot on the
shaft projecting through the back of
the barrel (
Figure 2).
Barrel
Feed Screw
Locking Pin