Grizzly H6247 - Manual (Page 9)

Model H6247 Meat Grinder -7 -
Figure 5. Inserting assembly
Figure 6. Switch location
9. Twist the feed screw so the vertical
slot on the feed screw aligns with
the vertical shaft on the inside of the
grinder head.
10. Slide the assembly into the grinder
head. Use the pin on the side of
the barrel as a guide into the slot.
Note– The vertical slot on the back
of the feed screw must align with the
vertical shank inside the grinder head
(
Figure 5).
ON/OFF and REVERSE Switch (Figure
6):
1. Turn the switch to the right to turn the
motor ON.
2. Turn the switch to the center position
to turn the motor OFF.
3. The REVERSE feature is handy for
clearing the cutting blade and cut-
ting plate of meat. Turn the switch to
the REVERSE position to REVERSE
the direction of the cutting blade.
WAIT UNTIL GRINDER HAS COME
TO A COMPLETE STOP BEFORE
REVERSING. The motor will only turn
in reverse as long as the REVERSE
switch is held in position.
11. Tighten the locking knob to secure the
assembly to the grinding head.
12. Set the hopper into the throat of the
grinder head ( Figure 6).
Controls
Figure 6. Inserting hopper