Grizzly G1021x - Manual (Page 16)

-14-
G1021X 15" Extreme Series Planer
Components and Hardware Needed: Qty
Extension Tables ............................................... 2
Hex Bolts M8-1.5 x 25 ....................................... 6
Set Screws M8-1.25 x 20 .................................. 6
To attach the extension tables:
1. Attach the extension tables to the planer
table with the hex bolts, as shown in Figure
6, but do not fully tighten the bolts at this
time.
2. Insert the set screws into the locations shown
in Figure 6.
Handwheel
Components and Hardware Needed: Qty
Handwheel ........................................................ 1
Handwheel Handle ............................................ 1
Key 4 x 4 x 10 .................................................... 1
Hi-Lo Scale ........................................................ 1
Hex Nut M10-1.25 .............................................. 1
Flat Washer 10mm ............................................ 1
To install the handwheel:
1. Fit the handwheel key into the keyway on the
handwheel shaft.
2. Slide the handwheel onto the handwheel
shaft, ensuring the key fits into the keyway
inside the handwheel bore.
3. Slide the Hi-Lo scale onto the handwheel
shaft, and secure the handwheel using the
included 10mm flat washer and M10-1.25
hex nut.
4. Thread the handwheel handle into the hole in
the handwheel, and tighten the jam nut.
Extension Tables
3. Using the straightedge as a guide, turn the
set screws individually until the extension
tables are level with the table, and then fully
tighten the hex bolts.
Figure 7. Handwheel installed on shaft
(handwheel handle removed for clarity).
Figure 6. Extension table attached to bed.
Hex Bolts and
Set Screws