Grizzly G1021x - Manual (Page 18)

-16-
G1021X 15" Extreme Series Planer
To perform a test run:
1. Read the entire instruction manual, and
make sure oil is in the gearbox.
2. Make sure all tools and foreign objects have
been removed from the machine.
3. Put on safety glasses, and secure loose
clothes or long hair.
4. Connect the planer to the power source.
5. Press the green button to turn the machine
ON. The planer should run smoothly with
little or no vibration.
—If you suspect any problems, immediately
stop the planer by pushing the red OFF
button. Troubleshoot and fix any problems
before starting the planer again.
— If you need any help with your planer call
our Tech Support at (570) 546-9663.
Loose hair and cloth-
ing could get caught
in machinery and
cause serious person-
al injury. Keep loose
clothing rolled up and
long hair tied up and
away from machinery.
Test Run
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum cutting
results. Keep this in mind as you start to use your
new planer.
Step-by-step instructions for these adjust-
ments can be found in SECTION 7: SERVICE
ADJUSTMENTS.
1. Table Parallelism (Page 25).
2. Chain Drive Tension (Page 25).
3. Infeed/Outfeed Roller Height (Page 27).
4. Spring Tension (Page 29).
5. Chip Breaker Height (Page 27).
6. Chip Deflector Positioning (Page 30).
Recommended
Adjustments
Tighten V-Belts
The final step in the set up process must be done
after approximately 16 hours of operation. During
this first 16 hours, the V-belts will stretch and seat
into the pulley grooves. After this time, the V-belts
must be retensioned or belt failure will occur
quickly. Refer to
Page 22 when you are ready to
perform this important adjustment.
Note: Pulleys and belts run very hot. This is a
normal condition. Allow them to cool before mak-
ing adjustments. A collection of black belt dust at
the bottom of the belt housing is a normal during
the life of the machine.