Grizzly G8994z - Manual (Page 8)

G8994Z Variable Speed Jig Saw
-6 -
The four settings for the orbital action of
the blade are controlled by a lever switch.
The effect of the settings is shown in
Figure 5 . When set on Position III the
blade oscillates forward in the stroke,
which is helpful when cutting wood or soft
materials. The Position 0 setting eliminates
all forward oscillation and the blade strokes
O OR RB BIIT TA AL L A AC CT TIIO ON N
3
2
1
0
straight up and down. This is good for
materials with a strong cutting resistance
such as metals and where a very clean cut
edge is desired.
Changes in the orbital movement can be
made with the motor turned on.
Fig 5. Orbital movement settings and typical materials for each selection.