GE Electric Built-In JP328 JP626 - Manual (Page 9)

BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
•
WARNING:
For personal safety, this
appliance must be properly grounded. See the
GROUNDING INSTRUCTIONS section in these
Installation Instructions.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
•
WARNING –
Before beginning the
installation, switch power off at the service panel and
lock the service disconnecting means to prevent
power from being switched on accidentally. When the
service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a
tag, to the service panel.
• To eliminate the risk of burns or fire by reaching over
heated surface elements, cabinet storage located
above the surface units should be avoided. If cabinet
storage space is to be provided, the risk can be
reduced by installing a range hood that projects
horizontally a minimum of 5
″ beyond the bottom of
the cabinets. Cabinet installation above the cooktop
may be no deeper than 13
″.
• The cooktop should be easy to reach and lighted with
natural light during the day.
FOR YOUR SAFETY:
Installation Electric Cooktop
Instructions
JP328, JP626
9
TOOLS YOU WILL NEED
• Electric or hand drill and 1/8
″ drill bit
• Flat blade screwdriver
• Phillips screwdriver
• Pencil
• Ruler
• Hand or saber saw
FOR TILE COUNTERTOP INSTALLATION
• Electric drill and 5/32
″ drill bit
• 4 3 ⁄
16
″ x 1
1 ⁄
4
″ masonry screws
Questions?
Visit our Website at:
ge.com or Call 1.800.GE.CARES (800.432.2737).
UNPACKING THE COOKTOP
Take cooktop from box and remove packing material:
• Paper under burner bowls
• Cardboard between cooktop and tub (must lift
cooktop)
• Tape holding support rod
This cooktop cannot be installed in countertops that
cannot accept screws, such as granite or marble, etc.