Grizzly G0560 - Manual (Page 17)

G0560 Meat-Cutting Bandsaw -15-
Figure 13. Motor mounted to motor mount.
Components and Hardware Needed: Qty
Motor ..................................................................1
Hex Bolt M8-1.25 x 20........................................4
Hex Nut M 8-1.25 ..............................................4
Flat Washer 8mm ..............................................8
Tools Needed:
Wrench or Socket 10mm....................................1
To install the motor:
1. Place the motor on the mounting plate so the
motor pulley is directly under the pulley slot
in the top of the stand.
2. Fasten the motor onto the motor mount (as
shown in
Figure 13) with the hex bolts, hex
nuts, lock washers and flat washers. The
washers should be placed on both sides of
the motor mount.
Motor
Figure 14. Wiring to switch plate.
After everything is wired correctly, take off the
nuts that hold the switch over the mounting hole
in the stand. Slide the rubber cover over the back
of the switch so no metal contacts are exposed.
Push the mounting screws through the holes on
the ends of the cover and thread the nuts back on
the screws. Tighten them securely, but not tight
enough to ruin the rubber.
The diagram in Figure 14 shows the proper
wiring of the motor and the power cord. The
ground wires mount underneath the switch with
the 10-24 x
1 ⁄
2
" Phillips screw, nut and star wash-
er. Do not pinch the wires while installing them. If
they will not reach, carefully cut back the outer
layer of the black cord.
Do not cut insulation on
the smaller wires inside!
Wiring