Grizzly w1702 - Manual (Page 15)

-13-
Handwheel
The handwheel comes installed from the
factory; however, you will need to install the
crank handle. NOTE: for each revolution of the
handwheel, the spindle moves up or down
approximately 0.045".
To install the crank handle, do these steps:
1. Thread the crank handle into the hole on the
face of the handwheel as shown in Figure 17.
2. Using a 14mm open-end wrench, tighten the
crank handle securely, making sure the hand
wheel rotates freely.
Figure 17. Attaching the crank handle.
Hold-Downs
The hold-downs hold the workpiece against the
fence and the table. NOTE: Remove the hold-
down assembly when not in use.
To install the hold-downs, do these steps:
1. Install two aluminum hold-down brackets
onto each of the hold-down bars as shown in
Figure 15.
2. Insert the long end of the hold-down bar
through the hole in the fence mount as
shown in
Figure 15.
3. Adjust the hold-down fence mount to the
desired position along the top edge of the
fence casting.
4. Screw in, but do not tighten, the 1 ⁄
4
"-20 x 3 ⁄
8
"
setscrews into the aluminum hold-down
brackets as shown in
Figure 15.
5. Slide each hold-down into the slot between
the aluminum hold-down bracket and hold-
down bar.
6. Position each of the hold-downs into place for
your workpiece as shown in Figure 16, and
tighten the setscrews in the fence mounts and
the aluminum hold-down brackets.
Figure 15. Assembling hold-down mechanism.
Figure 16. Assembled hold-down mechanism.
Hold-down
Bracket
ASSEMBLY