Grizzly H3123 - Manual (Page 20)

-18- H3123 Electric Guitar Kit
Mounting Pick
Guard
To secure the pick guard to the guitar body:
1. Position the pick guard so the 1st string is
centered over the corresponding round metal
pick-up peg as shown in
Figure 30 .
2. Secure the position of the pick guard to the
guitar body with masking tape.
3. Using a 3 ⁄
32
" drill bit, drill 1 ⁄
2
" deep holes
straight through the eleven holes in the pick
guard. Note—
Drilling the holes deeper than
1 ⁄
2
" could result in drilling out through the
back of the guitar body.
4. Secure the pick guard to the guitar body with
the included eleven
1 ⁄
2
" wood screws.
Figure 31. Mounting the back plate.
Figure 30. Pick guard mounting location.
Mounting Back Plate
Once mounted, the six holes in the back plate
need to align with the six holes in the tremolo
bridge. This will simplify the string installation and
removal process.
To mount the back plate to the guitar body:
1. Position the back plate over the cavity in the
back of the guitar body as shown in
Figure
31 .
2. Secure the position of the back plate to the
guitar body with masking tape.
3. Using a 3 ⁄
32
" drill bit, drill 1 ⁄
2
" deep holes
straight through the six holes in the back
plate. Note—
Drilling the holes deeper than
1 ⁄
2
" could result in drilling out through the front
of the guitar body.
4. Secure the back plate to the guitar body with
the included six
1 ⁄
2
" wood screws.