Grizzly G0710 - Manual (Page 28)

-26-
Model g0710/g0710p (Mfg. since 11/11)
dust collector operation
symptom possible Cause possible solution
dust collector does
not adequately
collect dust
or chips; poor
performance. 1. dust collection bag is full.
2. restriction in duct line.
3. the dust collector is too far away, or there
are too many sharp bends in the ducting.
4. the lumber is wet and dust is not flowing
through the ducting smoothly.
5. leaks in ducting or too many open ports.
6. ducting and or machine dust ports are
incorrectly sized.
7. the machine dust collection design is
inadequate.
8. the dust collector is too small for the
task or machine.
1. empty collection bag.
2. remove dust line from dust collector inlet and
unblock the restriction in the duct line. a plumbing
snake may be necessary.
3. relocate the dust collector closer to the point of
suction, and rework ducting without sharp bends.
refer to
collection system, beginning on page
16.
4. process lumber with less than 20% moisture
content.
5. rework the ducting to eliminate all leaks. Close
dust ports for lines not being used.
6. re-install correctly sized ducts and fittings. refer
to collection system beginning on page 16 for
more solutions.
7. use a dust collection nozzle on a stand.
8. use a larger dust collector.
sawdust being
blown into the
air from the dust
collector. 1. duct clamps or dust collection bag is not
properly clamped and secured.
2. Bag clamp is loose or damaged.
3. dust is extremely fine.
1. re-secure ducts and dust collection bag, making
sure duct and bag clamps are tight and completely
over the ducts and bag.
2. re-tighten bag clamp.
3. replace filter bag with grizzly Model h4340 3.0
micron type. install one or more grizzly Model
g0572 hanging air Filters.