GE 49-8830-1A - Manual (Page 28)

Operating Instr
uctions
Safety Instr
uctions
Car
e and Cleaning
Installation Instr
uctions
Tr
oubleshooting T
ips
28
International Installation Instructions.
(220–240, 50/60Hz, 2-wire)
Read these instructions completely and carefully.
Anti-Tip Bracket Installation
An Anti-Tip bracket is supplied with instructions for
installation in a variety of locations. The instructions
include a template, a parts list and a list of tools
necessary to complete the installation. Read the
Important Safety Information
and the instructions that
fit your situation before beginning installation.
WARNING
■ Range must be secured by Anti-Tip bracket
supplied.
■ See instructions to install (supplied with bracket).
■ Unless properly installed, the range could be
tipped by stepping or sitting on the door. Injury
might result from spilled hot liquids or from the
range itself.
Final Check
Be sure all range controls are in the OFF position
before leaving the range.
Typical installation of anti-tip bracket attachment to wall.
Bracket
Screw must enter
wood or metal Wall plate
Leveling the Range
The range must be level. Leveling feet are located at
each corner of the base of the range. Remove the
storage drawer or kick panel (depending on your
model) and using channel locks, rotate the leveling
feet in and out as required to level the range. (For
instructions on how to remove and replace the
storage drawer or the kick panel, see the Care and
cleaning of the range
section.)
On some models, there are plastic covers which
may be removed for easy adjustment (just squeeze
and pull).
One of the rear leveling feet will engage the Anti-Tip
bracket
(allow for some side to side adjustment).
Allow a minimum clearance of 3.2 mm (1/8²)
between the range and the leveling foot that is to be
installed into the Anti-Tip bracket.
Check the range for proper installation into the
Anti-Tip bracket
by removing the kick panel or
storage drawer and inspecting the rear leveling leg.
Make sure it fits securely into the slot.