GE 49-8830-1A - Manual (Page 21)

21
Tr
oubleshooting T
ips
Car
e and Cleaning
Installation Instr
uctions
Operating Instr
uctions
Safety Instr
uctions
Oven Light Replacement (on some models)
CAUTION: Before replacing your oven light
bulb, disconnect the electrical power to
the range at the main fuse or circuit
breaker panel.
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
Hold a hand under the cover so it
doesn’t fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt household
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to the
center of the cover until it snaps into
place.
Connect electrical power to the range.
Broiler Pan & Grid
After broiling, remove the broiler pan from
the oven. Remove the grid from the pan.
Carefully pour out the grease from the pan
into a proper container.
Wash and rinse the broiler pan and grid in
hot water with a soap-filled or plastic
scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with wet
paper towels or a dishcloth. Soaking the pan
will remove burned-on foods.
The broiler pan may be cleaned with a
commercial oven cleaner. If the grid is grey
enamel, it can also be cleaned with an oven
cleaner. If the grid is chrome, do not use an
oven cleaner to clean it.
Both the broiler pan and grid can also be
cleaned in the dishwasher.
Do not store a soiled broiler pan and grid anywhere
in the range.
After broiling, remove the broiler
pan from the oven.
How to Remove the Storage Drawer or Kick Panel to Clean Under the Range
To remove the storage drawer:
Pull the drawer out all the way.
Tilt up the front and remove it.
To replace the storage drawer:
Insert glides at the back of the drawer
beyond the stop on range glides.
Lift the drawer if necessary to insert
easily.
Let the front of the drawer down, then
push in to close.
To remove the kick panel, pull it straight out
at the bottom.
To replace the panel, first hook the top tabs
on and then the bottom tabs.
Clean under the range.
Wire cover holder