GE 49-8830-1A - Manual (Page 27)

Tr
oubleshooting T
ips
Operating Instr
uctions
Read these instructions completely and carefully.
Safety Instr
uctions
Car
e and Cleaning
Installation Instr
uctions
2-Wire Power Cord Installation
WARNING:
THE POWER LEADS
MUST BE CONNECTED TO THE OUTSIDE (BRASS
COLORED) TERMINALS. THE GROUND (EARTH)
LEAD MUST BE CONNECTED TO THE FRAME OF
THE RANGE WITH THE GREEN GROUNDING
SCREW.
RANGE FRAME MUST BE GROUNDED PROPERLY
TO AVOID POTENTIAL ELECTRICAL SHOCK.
Remove the 2 screws from the connector block.
Remove the grounding screw and strap from
the connector block middle location and the
screw connecting it to the frame of the range.
Insert screws through each power cord
terminal ring and into connector block until
screw engages nut. Tighten screws securely.
Attach ground (earth) wire to the frame of the
range. This is the green, or green with yellow
stripe, wire.
After
Before
Green screw grounds
range to earth (ground)
Green grounding screw and
plate (grounding to range)
Red “L” (Line)
Black “N” (Neutral)
2-Wire Conduit Installation
WARNING:
CONNECTOR BLOCK IS
APPROVED FOR COPPER WIRE CONNECTION
ONLY. IF ALUMINUM WIRE IS USED, SEE NOTE
BELOW.
Remove the 2 screws from the connector block.
Remove the grounding strap from the connector
block middle location and the screw connecting it to
the frame of the range. Insert bare wires between
the connector block terminals and movable nuts.
Tighten screws securely. Attach ground (earth) wire
to the frame of the range.
NOTE: ALUMINUM WIRING
Do not connect aluminum wire to connector
block. Use copper building wire rated for the
correct amperage and voltage to make 3
(three) 7.62 cm (3-inch) copper jumper wires.
Connect wire as described above.
Splice copper wires to aluminum wiring using
special connector terminals designed for
joining copper to aluminum and follow the
connector manufacturer’s recommended
procedure closely.
Wire used, location and enclosure of splices, etc., must
conform to good wiring practices and local codes.
27
Screw
Flexible
cable
Bare wire
tips
Conduit
Bracket
Connector block
terminal
Movable nut
Bare wire
Connector
block